EASY STEP-BY-STEP
INSTALLATION
|
|
IMPORTANT - The Ready
Rider®
should be installed and used strictly by an adult.
Please refer to drawing for part identification. Part numbers in ( ) in
Step 1.
|
STEP 1
Insert Handle Grip
(1) onto Rider Handle (2) and then insert the Rider Handle into the Rear Fork
(3) (be
sure to line up holes). Align holes in Stabilizer Bar (4) and Rear Fork,
then insert Carriage Bolt (5) through both. Partially tighten Lock Nut
(6) (see photo 1).
|
|
|
|
|
STEP 2
Loosen nuts on rear wheel axle. Place Rear Fork slots onto axle
securely, then partially tighten axle nuts (see photo 2). Insure
wheel is centered in the bike frame and not rubbing on either side of
frame.
|
|
|
|
|
STEP 3
Remove seatpost clamp nut and place Stabilizer Bar onto bolt and
retighten nut securely to 100 inch/lbs (see photo 3). Then tighten
carriage bolt on Ready Rider assembly to 180 inch/lbs and read wheel
axle nuts to 240-300 inch/lbs.
|
|
PLEASE NOTE!
The Ready Rider®
can also be used along with training wheels (balancers). Just
loosen the rear wheel axle nuts and place the Rear Fork slots on the
axle outside of the training wheel support struts. Then tighten
rear axle nuts to manufacturer's specs (240-300 inch/lbs.).
|
